Pinterest Inspired Simple Camera Bag and Kids Backpack Tutorials!

SLR Camera Bag

I am a member of the Collective Bias® Social Fabric® Community. This shop has been compensated as part of a social shopper insights study for Collective Bias and their client.

For a long time I have salivated over the cameras of others, looking down on my humble compact and feeling somewhat inferior. I dearly love photography, even possessing a photography qualification but since the introduction of digital cameras, an SLR has alluded me. So when I write that I am now the proud owner of a beautiful Canon DSLR you will understand my paranoid need to protect it. However my own personal sense of style demands that I don’t just buy any old camera bag, I wanted something that suits me and my lifestyle.

Pinterest Camera Bags #shop

Pinterest Camera Bags

I began to research into camera bags and cases, but I found none that I liked 🙁 With a family trip looming I turned to Pinterest for inspiration and created my own camera bag based around some of the bags that I viewed. Some of these were available to buy from stores and some had been handmade.

Pinterest Backpacks #shop

Pinterest Backpacks

I also wanted to make my kids some simple backpacks to hold a few bits and bobs to keep them occupied during our trip, again I found a great deal of inspiration on Pinterest. I shopped for the majority of my supplies at Wilkinsons and you can see my shopping trip by clicking here.

Kids Backpacks #shop

Kids Backpacks

I’m rather proud of my finished bags 🙂 The camera bag could perhaps benefit from some extra pockets or internal dividers but for my own personal needs it works brilliantly. The kids bags are comfortable and practical and they love them. If you would like to make your own version of either of my bags the instructions are below 🙂

SLR Camera Bag

Simple Camera Bag Tutorial

Supplies:

2 pieces of liner fabric 36cm (w) X 30cm(h) with 9cm squares cut out of bottom of width

2 pieces of outer fabric 36cm(w) X 30cm(h) with 9cm squares cut out of bottom of width

2 pieces of pvc fabric 36cm(w) X 30cm(h) with 9cm squares cut out of bottom of width

1 piece of foam 18cm X 16.5cm

2 pieces of foam 18cm X 18cm

2 pieces of foam 15cm X 18cm

2 pieces of 10cm square of outer fabric

2 D-rings

1 piece fabric 36cm X 19cm for flap

1 piece pvc fabric 36cm X 19cm for flap

1 piece Lining Fabric 36cm X 19cm for flap

1 piece of fusible Interfacing 36cm X 19cm for flap

2 buckles or clasps

Straping/webbing for bag strap

Velcro

Step 1 #shop

Step 1

1. Begin by pinning the pvc fabric to the outside fabric pieces on the wrong side of the outer fabric. Zigzag around each piece to attach the pvc to the outer fabric.

2. Pin the two outer fabric pieces right side together. Sew across the bottom and down the sides, but do not sew any part of the square shape, we are creating a T seam. I used a 3/8” seam allowance. Repeat step with lining fabric. You should now have two open box shapes.

3. Squash the (cut out) square shape flat, lining up seams and then sew across to create a T seam, do this on the outer and liner fabric pieces.

Step 3 #shop

Step 3

4. Take the foam piece 18cm X 16.5cm and stitch by hand to the bottom of the liner fabric on the wrong side (against raw seams). Do not attach the side pieces of foam, we’ll slot them in later.

5. Take one of the 10cm squares of outer fabric, zigzag around the entire square. Iron over approximately 1cm on each side of the square, then iron in half length ways.

6. Sew along the edge to close, then pass through the D-ring and sew to the side seams of the outer fabric box to make loops for the bag strap.

7. Take the flap outer fabric & PVC fabric and attach them together by zig zagging around the edge. Iron the fusible interfacing onto the lining flap piece.

8. Pin the outer fabric flap piece to the flap lining piece right sides together and sew around three edges, turn the flap out the right way. Press and then edge stitch around three edges of the flap, still leaving the back edge free.

9. Sew half of the buckles to the bottom edge of the flap. Sew the other side of the buckles to the right side of the outer fabric (you may need to pin your flap in place temporarily to find the correct position).

Step 9 #shop

Step 9

10. Turn the outer fabric inside out, sew the flap to the outer fabric (right sides together).

11. Place the liner fabric box inside the outer fabric box (right sides together, so bag looks inside out), line up the seams and sew across the sides and flap seam, leave the other seam free. Turn the bag the right way out through the open seam. Wiggle the foam side pieces into position and then push the liner back in on top of them. Hand stitch the open seam closed.

Step 11 #shop

Step 11

12. Next to create the completed box shape we need to secure the flap and stop the sides gaping by sewing Velcro to the sides of the box bag at the top and to the corresponding side edges of the flap.

Step 12 #shop

Step 12

13. Finally pass the straping through the d-rings and stitch to attach. To be really secure I like to sew a square shape with an X shape inside.

That’s it done!

Child's Backpack #shop

Child's Backpack

Childrens Backpack Bag Tutorial

I loved the design of the bags I had seen on Pinterest, however as I wanted the bags to be worn on a day out I wanted them to be really strong, so I decided to line them internally to add extra strength. Here are the instructions for my version of a drawstring backpack.

Supplies:

2 pieces of outer fabric 38cm X 33cm

2 pieces of lining fabric 38cm X 33cm

2 pieces of outer fabric 8cm X 4cm (to make loops for the cord to pass through)

Cord or String

1. Make the loops first by folding the small pieces of outer fabric lengthways and iron. Open out and fold each side to the middle and then fold in half again so you end up with something that is 8cm by 1 cm. Sew along the open edge and iron.

2. For the bag sew the lining to the outside fabric along one of the shorter edges having placed the two pieces of fabric right sides together. I used a small seam allowance which was the width of my machine foot.

3. I then neatened these seams with a zig zag stitch and then folded both pieces to one side, ironed and then machined very close to the edge to keep it flat and to make sure it would not get in the way once the cord was added.

4. Having joined the outsides and linings I placed the two pieces of the bag one on top of the other to sew the side seams. Firstly you must position the loops near the bottom of the outside fabric. I placed mine about 3cm from the edge that will become the bottom of the bag.

5. The joined part of the loop will be facing the centre with the two open ends hanging about 1cm outside the edge of the fabric. Pin or tack these in place and they will be secured when you machine the edges together.

6. The outside pieces will be one on top of each other right sides together and the same with the lining pieces.

7. To sew round the bag start with one of the lining sides and sew together about 1cm in and sew up the side until you are 1.5cm from the fabric join. stop sewing and start again 1.5cm along the side of the right side fabric. You have then a gap in the machining of 3cm.

8. Now continue sewing down the side of the outside fabric over the loop (to strengthen this I went backwards and forwards a few times), across the bottom edge and up the next side again leaving the gap of 3cm. Do not sew across the bottom of the lining.

9. Iron all the seams open and then neaten with a zig zag stitch. Where the gaps were sew these pieces back with a straight sewing stitch to stop these pieces getting in the way once the cord is put through.. Also iron a 1cm turn up on the piece of lining fabric which will make it easier to sew once turned the right way out. Now turn the bag the right way out. Machine the lining closed about 3mm from the edge and then push down inside the bag. To make the tunnel for the cord sew around the bag 1.5cm from the edge where you will have made the gap at the sides and again to strengthen machine back and forwards a few times at the opening in the sides.

10. Now thread some suitable cord though the bag. If using one long piece this should be about 182cm long. You can also make these bags using two pieces of cord, which is easier to close but perhaps less suitable for a child as they could potentially pull the bag closed accidentally (over their head etc).

Child's Backpack #shop

Child's Backpack

Kids Summer Fashion for a Day Trip!

When it comes to childrens fashion there is always an element of practicality to consider, after all kids can be notoriously rough on their clothes. So how do you dress fashion conscious children for a long tiring day trip? I found the answer at Westfield Derby in one of this season’s top trends…..neon! I took my three to London to test their neon clothes in action.

Neon isn’t always in favour but it can’t be denied that it is bright and noticeable. This in itself makes it the perfect colour to dress your kids in, simply put they are easier to spot which is a distinct advantage if you are visiting a busy area. It also means they are easier to describe should you lose sight of them temporarily.

However unless you want to make your kids look like 80’s rejects you have to play the neon card carefully. I found a wonderful variety of clothes in my local shopping centre (Westfield Derby), where a few designs were on offer in store.

For my eldest son I went for this gorgeous layered top from Zara, it’s quite oversized in design and is available in a range of colours, it’s bright but it wont damage your retina and I can spot him at a distance. I paired this with a more understated pair of navy shorts from H&M, these have a slightly tailored cut which means they can be dressed up or down. He also had a bright neon blue belt, also from H&M although admittedly his t-shirt covered this.

For my youngest son I went for these gorgeous denim shorts from Zara, they are bright, incredibly comfortable and my son loves them. Zara also do similar trousers in bright designs, although I found their legs were slimmer which made them less practical for a very little person.

I paired them with this fabulous Darth Vader t-shirt from H&M. The t-shirt has the added advantage of being glow in the dark, I know he went under a table to show me!

For my daughter I toned done the neon just slightly with this pink skirt from H&M with neon heart accents. This was paired with an incredibly funky animal print t-shirt (also from H&M) and bright wrist cuff.

I think they all looked fabulous, but how did the clothing fair on our trip? From beginning to end it was an insanely long hot day (the hottest day of the year in the South East) but while I wilted in the background all the kids were comfortable, fashionable and practically dressed.

Details

All the clothes were bought from Westfield Derby

Orange Layered Top £3.99 from Zara (this was reduced from £6.99)

Navy Shorts £7 from H&M (these were on special offer in store)

Blue Belt £2.50 from H&M

Orange Shorts £9.99 from Zara (these were reduced from £14.99)

Darth Vader T-shirt £5.99 from H&M

Pink heart skirt £5.99 from H&M

Animal Print T-shirt £2.99 from H&M

Wrist Cuff £1.99 from H&M